Home / Standing Desk / FlexiSpot
FlexiSpot E7 Pro Dual-Motor Standing Desk
FlexiSpot · E7 Pro · Standing Desk
⏱ Assembly Time: 45-60 min
Open in AssembleIQ →
Full interactive guide: save this job offline, get stuck-step help, and more.
Tools Needed
- Allen/hex key (included)
- Phillips screwdriver
Parts Checklist
- Left and right dual-motor legs
- Crossbar
- Control box + keypad
- Desktop
- Anti-collision sensor cable
Critical Steps
- Keep the frame square (measure diagonals if unsure) before final tightening, or the desk will bind when raising/lowering.
- Connect the anti-collision sensor cable before first power-on — it's what stops the desk if it hits an obstacle while rising.
Pro Tips
- Assemble the frame upside-down on the desktop, same as most electric standing desks — legs and crossbar go on first, then flip as a unit.
- Don't fully tighten any bolt until the whole frame is assembled and square — makes final alignment much easier.